Pumptec

HP Volts Hz Model Number 1/3 - 1 1/2 115/230 60 580 002 0116 1/3 - 1 1/2 220 50 580 002 0516   Shipping Weight Carton Size W x D x H 2.9 lbs 1.3 kg 5 1/4" x 3 1/4" x 8 7/8"

Applications PUMPTEC PROTECTS A 4" FRANKLIN ELECTRIC SINGLE PHASE MOTOR AGAINST: Low yield wells Low voltage Air or gas locked pump Drop in water level Clogged well screen Broken shaft or coupling Worn pump parts Specifications ENCLOSURE - Type 3R, IP23. Suitable for outdoor mounting, not gasketed, two holes for wall mounting at back of box. Bottom of box has two 7/8" and one 1 1/8" knockouts. Each side of box has one 7/8" and one 1 1/8" knockout. Wiring diagram included for easy installation. SOLID STATE - Solid state circuitry with run light, automatically shuts off a pump when a fault condition exists and illuminates the "Tripped" light. Equipped with signal circuit for remote tripped indication. RESET TIME — Preset at the factory for 30 minutes, but can be adjusted from 2 minutes to 90 minutes, or for manual reset only. UL/cUL listed

Franklin Electric makes three types of Pumptec motor protection devices, the QD Pumptec, the Original Pumptec and the Pumptec+. The units are solid state load sensing mechanisms that will shut the pump off if they detect low current consumption commonly associated with clogged pump inlet screens, air or gas locked pumps, broken motor shaft couplings, and low well yields.

The QD Pumptec is made exclusively to plug into a Franklin QD control box. It will shut off any Franklin single phase, 3-wire motor when the load drops below a preset level for a minimum of four seconds. This model only works with 230 volt control boxes.

The original Pumptec is designed for 2 and 3 wire motors 1/3 to 1.5 Hp. This is a stand alone unit.

The Pumptec Plus protects ½ through 5 Hp. single-phase motors, it comes with a 30 amp contactor and a current transformer. It will protect against low well yields, high or low voltages, short cycling, power surges, running dry , cavitation or air locked impellers, water logged tanks, and clogged pump suction inlets